• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 31 subscribers
  • Views 672 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

DCA1000EVM: When I use DCA1000EVM and IWR1443BOOST,can I use the cfg file for IWR1443BOOST?

user5205609
Intellectual 960 points
Part Number: DCA1000EVM
Other Parts Discussed in Thread: IWR1443BOOST

Hi,

Please tell me about the subject of the topic.

I use DCA1000EVM and IWR1443BOOST.

Can I apply the cfg file created by IWR 1443 BOOST Visializer Demo
to IWR 1443 BOOST when I use the above connection?

There is a "Load Config" button on the screen of mmWave Studio,
but the format which can be used is ".xml".

Regards,
user5205609

  • 0
    TI__Mastermind 24955 points
    mmWave Studio is used as a development or evaluation platform. It does not take configuration (*.cfg) files that you would use when running the Visualizer Demo. However, you can extract the values from the configuration file and apply them in mmWave Studio.

    You will need to Reference the SDK User's Guide that is found in the docs folder of the SDK installation. You can cross reference the CLI commands and their associated parameters from the User's Guide and map those values to the corresponding location in mmWave Studio.

    The "Load Config" option in mmWave Studio is used to load a previous configuration of mmWave Studio, not a cfg file that is used in the Visualizer Demo.

    Regards,
    Kyle
  • 0 in reply to Kyle Cousino
    Intellectual 960 points

    Hi,

    Thank you very much.

    I will check the documents.

    Regard,

    user5205609