• State TI Thinks Resolved
  • Locked Locked
  • Replies 3 replies
  • Answers 2 answers
  • Subscribers 30 subscribers
  • Views 610 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Linux/AWR1642BOOST: How to flash AWR1642BOOST with out of box demo ?

Krishna Rao40
Prodigy 80 points
Part Number: AWR1642BOOST
Other Parts Discussed in Thread: UNIFLASH

Tool/software: Linux

How to flash out of the box demo in AWR1642BOOST?

  • 0
    TI__Mastermind 24955 points
    Krishna,

    To flash pre-compiled binaries, you should use TI's Uniflash tool that can be found here: processors.wiki.ti.com/.../Category:CCS_UniFlash

    Regards,
    Kyle
  • 0 in reply to Kyle Cousino
    Prodigy 80 points
    Thanks Kyle.
    And sorry for the delay.
    But how can i know what bin files my board AWR1642BOOST RevA can support?
    Since i wanted to flash Out of the box demo.bin on my board, i asked this doubt.
    Thanks in advance.
  • 0 in reply to Krishna Rao40
    TI__Mastermind 24955 points
    Krishna,

    You will need to read the device markings on your chip to determine which silicon version that you have. If the bottom line on the chip reads "502", then you have an ES 1.0 device. If the bottom line on the chip reads "502AC", then you have an ES 2.0 device. You will need to cross reference this information with the release notes to see which silicon version is supported.

    If you have an ES 1.0 device, then you should download SDK v1.2.

    If you have an ES 2.0 device, then you should download SDK v2.0.

    For any of the labs found in either the automotive toolbox or the industrial toolbox, you will need to double check the release notes to make sure your device is able to run a particular lab based on the SDK version it is based off. You have the option to download previous versions of both the automotive and industrial toolbox. Please search this forum to understand how to do this as this question has been addressed already.

    Regards,
    Kyle