AWR1243: Beamforming support

Koichiro Tashiro

Mastermind 22945 points

Part Number: AWR1243
Other Parts Discussed in Thread: DCA1000EVM

Hi,

According to below E2E thread, beamforming is supported in only AWR1243P.

Is there any plan to release similar device for IWR?

https://e2e.ti.com/support/sensor/mmwave_sensors/f/1023/t/596975#pi320098=2

And when AWR1243P will be available?
AWR1243PBOOST + DCA1000EVM will be needed for customer evaluation?

Thanks and regards,
KoT

over 7 years ago

0 Kyle Cousino over 7 years ago

TI__Mastermind 24955 points

KoT,

I will check with marketing to see if this is information that can be posted to this forum. Check back tomorrow for a follow-up response from me.

Regards,
Kyle

0 Koichiro Tashiro over 7 years ago in reply to Kyle Cousino

TI__Mastermind 22945 points

Hi Kyle,

Any updates for this item?

Thanks and regards,
KoT

0 Koichiro Tashiro over 7 years ago in reply to Koichiro Tashiro

TI__Mastermind 22945 points

Could you reply to this item?

0 Kyle Cousino over 7 years ago in reply to Koichiro Tashiro

TI__Mastermind 24955 points

KoT,

As of now, I have the following information that I can share on this platform.

There are no plans to release an IWR variant similar to the AWR1243P.

A release date for AWR1243P cannot be provided on E2E at this point in time.

There are no plans to release an AWR1243PBOOST EVM. Since this device will be primarily used in a cascaded solution, the recommended evaluation platform would be the cascade radar board that will be released on ti.com.

Regards,
Kyle

Sensors

Sensors forum

AWR1243: Beamforming support