Linux/IWR1443BOOST: Low Power

Rupak Dasgupta

Intellectual 400 points

Part Number: IWR1443BOOST
Other Parts Discussed in Thread: IWR1443

Tool/software: Linux

I am using the IWR1443BOOST with ROS on a Linux machine.

Is there documentation on how to use the lowPower parameter in the config file?

Thanks.

over 6 years ago

0 Kyle Cousino over 6 years ago

TI__Mastermind 24955 points

Rupak,

Please refer to the SDK User's Guide, which is found in the docs folder of the SDK installation. You can search from "lowPower" and the User's Guide will provide all of the necessary information about this CLI command.

Regards,
Kyle

0 Rupak Dasgupta over 6 years ago in reply to Kyle Cousino

Intellectual 400 points

Hi Kyle,

It just says that the '0' value has been tested for the IWR1443. Is it related to the Board Specific Parameters in the Sensing Estimator? Or is it just a 0/1 value to be set in the config file?

Thanks.

0 Kyle Cousino over 6 years ago in reply to Rupak Dasgupta

TI__Mastermind 24955 points

Rupak,

It is a 0/1 value that is set in the config file according to the User's Guide.

Regards,
Kyle

0 Rupak Dasgupta over 6 years ago in reply to Kyle Cousino

Intellectual 400 points

Thanks Kyle!

Sensors

Sensors forum

Linux/IWR1443BOOST: Low Power