Piezo Ultrasonic Driver for Structural Health Monitoring.

Kyaw Thu

Prodigy 20 points

May I check TI product range for Piezo Ultrasonic Driver for Structural Health Monitoring?

Specifications are as below

1. 50 - kHz to 5 MHz range.

2. Multiple channel support

3. APC-850 Piezo Sensors

over 6 years ago

0 Ivan Salazar over 6 years ago

TI__Guru** 109055 points

Hi Kyaw,

Welcome to e2e.
Can you please provide an e-mail address so I can contact you directly?
Once we establish offline contact I'll close this thread on the forum.

Best regards,
-Ivan Salazar
Applications Engineer - Low Power Audio & Actuators

0 Ivan Salazar over 6 years ago in reply to Ivan Salazar

TI__Guru** 109055 points

Kyaw,

Have you found a device that fits your application?
If not please reply to this message or post a new question on the forum. Low Power Actuator drivers might not be able to drive such high frequencies but perhaps another team could provide some suggestions.

Best regards,
-Ivan Salazar
Applications Engineer - Low Power Audio & Actuators

0 Kyaw Thu over 6 years ago in reply to Ivan Salazar

Prodigy 20 points

Hi Ivan,

My email address is kthu@energyrecovery.com.

Thanks.

0 Ivan Salazar over 6 years ago in reply to Kyaw Thu

TI__Guru** 109055 points

Kyaw,

I'll contact you offline and I'm closing this thread.

Best regards,
-Ivan Salazar
Applications Engineer - Low Power Audio & Actuators

Sensors

Sensors forum

Piezo Ultrasonic Driver for Structural Health Monitoring.