PGA300: PGA300: Calibration tool and mass production tool

Xiaowei Bai1

Part Number: PGA300

Hello Team,

my customer has been finished the PGA300 development, now they need to develop the calibration tool and mass production tool, so customer want to get the TI example code to improve it to mass production. can you help to provide the code? thanks..

over 6 years ago

0 Tom Hendrick over 6 years ago

TI__Guru**** 181001 points

Hi Xiaowei,

Any software for a mass production tool will be by default, tool dependent. Are you building your won custom hardware? What processor do you intend to use?

0 Xiaowei Bai1 over 6 years ago in reply to Tom Hendrick

TI__Intellectual 1205 points

Hello Tom,

yes, customer want to building their own mass production tools, for the processor, I don't know what processor will be used in customer side, I think that is ok we just provide the c code. thanks...

0 Scott Cummins over 6 years ago in reply to Xiaowei Bai1

TI__Mastermind 31655 points

Hi Xiaowei,

We do not have mass calibration tool software source code available for distribution. The software for the EVM GUI is also not available in source code form since it includes proprietary information about the PGA300 compensation algorithm.

We do have a DLL that can be used to calculate the compensation coefficients after a calibration routine is performed. Please message me directly to discuss this.

Regards,

Sensors

Sensors forum

PGA300: PGA300: Calibration tool and mass production tool