AWR1642BOOST-ODS: SEND CONFIG TO MMWAVE DEVICE

Masaaki Sugiyama68

Expert 1445 points

Part Number: AWR1642BOOST-ODS

Deara support team;

I use AWR1642BOOST-ODS and ODS Demo Visualizer.

When I pushed "SEND CONFIG TO MMWAVE DEVICE" after parameter defined, anythng can not occured.

Could you tell us how to customize these parameters?

Best Regards,

Masaaki Sugiyama

over 6 years ago

0 Kyle Cousino over 6 years ago

TI__Mastermind 24955 points

Masaaki,

You can use the "Plots" tab in the ODS Demo Visualizer and then upload the configuration file (.cfg) to the device. The configuration file is included in the Obstacle Detection (ODS) lab on TI's Resource Explorer and can be found here: dev.ti.com/.../

Regards,
Kyle

0 Kyle Cousino over 6 years ago in reply to Kyle Cousino

TI__Mastermind 24955 points

Masaaki,

We have also released a new MATLAB GUI for the ODS board which you can download from the link in my previous post. You can use this visualizer offline too.

Regards,
Kyle

0 Masaaki Sugiyama68 over 6 years ago in reply to Kyle Cousino

Expert 1445 points

Dear Kyle-san;
Thank you for your quick support and infomation.
I confirmed the new MATLAB GUI.
Best Regards,
Masaaki Sugiyama

Sensors

Sensors forum

AWR1642BOOST-ODS: SEND CONFIG TO MMWAVE DEVICE