DCA1000EVM: DCA1000EVM FPGA configuration switch : What does it mean??

MARAT LUSIENYCH

Part Number: DCA1000EVM

HI everybody!! Please help me understand how to set right FPGA Configuration Mode in DCA1000EVM. In datasheet there is only small table and nothing more about. What do all these modes mean? Screenshot from datasheet

below

over 6 years ago

0 Jitendra Gupta over 6 years ago

TI__Guru 70100 points

Hi,
This switch series lines are used to flash a new FPGA image to DCA1000 with the file provided in mmWave Studio package (mmWaveStudio\DCA1000FPGA\*.bit) using Lattice Diamond Programmer tool.

Regards,
Jitendra

0 MARAT LUSIENYCH over 6 years ago in reply to Jitendra Gupta

Prodigy 180 points

Оk, i downloaded file from mmwave studio 2.0 (DCA1000_FPGA_RECORD_V2.7_18JUN2018) . And how I need to set these switches properly?? I can't understand at all...

0 Jitendra Gupta over 6 years ago in reply to MARAT LUSIENYCH

TI__Guru 70100 points

Hi,

Default firmware on DCA1000 should work as it is, in case you are facing some issue in some scenario then only you need to update the DCA100 FPGA firmware. Based on your response (answer to yes) to your other thread for DCA1000 issue, it looks like the issue has been resolved at your end.

Even if you need to update DCA1000 FPGA firmware, please go through section-9 of DCA1000 user guide.

http://www.ti.com/lit/ug/spruij4/spruij4.pdf

Regards,

Jitendra

Sensors

Sensors forum

DCA1000EVM: DCA1000EVM FPGA configuration switch : What does it mean??