AWR1243: How to set GPIOs of AWR1243

min hu

Intellectual 990 points

Part Number: AWR1243

Hi,

I would like to use GPIOs of AWR1243 and set GPIO_0 as "FUNC_ADC_Valid",how should i set？

Best Regards.

over 6 years ago

0 Anand Gadiyar over 6 years ago

TI__Genius 15005 points

Hi Min,

I'm afraid we do not currently support this in our APIs.

Best Regards,
Anand

0 Anand Gadiyar over 6 years ago in reply to Anand Gadiyar

TI__Genius 15005 points

Hi Min,

Please note: you can still enable this by using the RegOp tab in mmWave Studio.

Best Regards,
Anand

0 min hu over 6 years ago in reply to Anand Gadiyar

Intellectual 990 points

Hi,
Is there any way to use mmWave Studio with customer board?

0 Anand Gadiyar over 6 years ago in reply to min hu

TI__Genius 15005 points

Hi Min,

If the customer board exposes the AWR1243 SPI interfaces via an FTDI chip similar to our Devpack/Booster pack, then mmWave Studio might work.

Otherwise, I'm afraid we do not support this for now.

Best Regards,
Anand

Sensors

Sensors forum

AWR1243: How to set GPIOs of AWR1243