CCS/AWR1642: Enable Receive only mode in AWR1642

prateek hegde

Intellectual 380 points

Part Number: AWR1642

Tool/software: Code Composer Studio

Dear all,

Is it possible to configure the awr1642 family device in only receive mode?

Only Tx should be off but internal chirp should be generating for generating the beat.

Is it possible to achive this with this chipset?

Thanks in advance,

Prateek

over 5 years ago

0 Jitendra Gupta over 5 years ago

TI__Guru 69000 points

Hi Prateek,
Could you please elaborate your use case, what is your goal to achieve with this device?

Regards,
Jitendra

0 prateek hegde over 5 years ago in reply to Jitendra Gupta

Intellectual 380 points

Yes,
I want to make one device Just receives the Signal and process it. It should not transmit.
I will transmit from other device. So I want a device where I can configure for only receive , When required transmit(Normal Radar Operation).
If 66GHz new chipset TI launched right that works for me is also fine enough.

Thanks in advance

0 Anand Gadiyar over 5 years ago in reply to prateek hegde

TI__Genius 14655 points

Hi Prateek,

The TXs can be turned off individually in all chirps in all our AWR and IWR devices. You can simply configure chirps with no TX enabled and the devices will receive radar data on all enabled RX channels.

Best Regards,
Anand

0 prateek hegde over 5 years ago in reply to Anand Gadiyar

Intellectual 380 points

Thank you I will check that

Sensors

Sensors forum

CCS/AWR1642: Enable Receive only mode in AWR1642