MMWAVE-SDK: Plotting CFAR threshold

Helma Maf

Intellectual 280 points

Part Number: MMWAVE-SDK

Hi All,

Is it possible to plot the CFAR threshold in the range profile of the mmWave Visualizer Demo?

as shown below?

over 6 years ago

0 Jitendra Gupta over 6 years ago

TI__Guru 69960 points

Hi,

That is possible by changing the visualizer source code which you can do by importing mmwave demo visualizer to dev.ti.com/gallery under your login.

Regards,

Jitendra

0 Helma Maf over 6 years ago in reply to Jitendra Gupta

Intellectual 280 points

Thanks for your response Jitendra...

But there are tones of lines of code and I am not sure which code to change.

0 Jitendra Gupta over 6 years ago in reply to Helma Maf

TI__Guru 69960 points

Hi Helma,
In visualizer mmwave.js: ti_widget_plot is the holder for any plots where after processing it fills up the data to plot it.
In the index.gui you can map these holders to corresponding visualizer plots.

as exmaple mmwave.js: plotScatterpoints function does the x/y/z scattered plot/range-doppler plot to visualizer.

You need to go over source code only to find out the solution to match your requirement.

Regards,
Jitendra

Sensors

Sensors forum

MMWAVE-SDK: Plotting CFAR threshold