• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 31 subscribers
  • Views 354 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

AWR1443: LVDS data capture issues

Madan K Avhad
Expert 1260 points
Part Number: AWR1443
Other Parts Discussed in Thread: MMWAVE-STUDIO

Hi,

I'm trying to capture raw data using DCA1000 board with awr1443 ES3.0 device. The radar studio 2.0 version are using. The radar studio show error 'firmware mismatch', is there any methods to fix it. Does radar studio 2.0 uses same binary as mmwave sdk 2.1 uses? 

  • 0
    TI__Guru 69990 points
    Hi Madan,
    With mmWave-Studio 2.0 version you should able to use AWR1443 ES3.0 device. Make sure that you have set jumpers correctly to make it in development mode (SOP0:1, SOP1:1, SOP2:0). Even though it throws firmware mismatch error, are you able to proceed further, means able to send SPI commands? Sometimes it may see firmware mismatch if you download file multiple times, but if device is responsding correctly then this error should not hamper the flow.

    Binaries are different in Studio and SDK.

    Regards,
    Jitendra
  • 0 in reply to Jitendra Gupta
    Expert 1260 points
    Thanks, its working.