AWR1642BOOST：how to use USRT to control the radar to start and stop

Daniel Guo

Prodigy 210 points

Part Number: AWR1642BOOST

I want to send command by USRT directly to control the radar start and stop.

But I don't know which command should I send.

Is there a manual for user to check command to config and control by USRT port?

over 6 years ago

0 Jitendra Gupta over 6 years ago

TI__Guru 69960 points

Hi,
Please refer mmWave SDK user guide which explains about all supported CLI (UART) commands to configure the device/application.
sensorStart & sensorStop are the commands to send over UART, but with the existing mmw demo application you must need to send all other configuration before sending sensorStart.

Regards,
Jitendra

0 Daniel Guo over 6 years ago in reply to Jitendra Gupta

Prodigy 210 points

Hi,

Ya,I viewed the CLI commands in user guide.

And I want to check that all command must be sent before the command sensorStart?

I want to send command according the console messages in Visualizer tool as the picture. Is it a right thought?

0 Jitendra Gupta over 6 years ago in reply to Daniel Guo

TI__Guru 69960 points

Hi,
I don't totally get your query here but let me reply based on what I understood.

mmw demo takes care of all the dependent CLI commands (if any command is missing in the order), please refer mmw demo source code for more info (cli.c, mmwave_cli.c ).

And you can use TeraTerm or any other terminal application to send these CLI commands instead of Visualizer to the device.

Regards,
Jitendra

0 Daniel Guo over 6 years ago in reply to Jitendra Gupta

Prodigy 210 points

hi,

Thanks.I got it.

Best wishes.

Sensors

Sensors forum

AWR1642BOOST：how to use USRT to control the radar to start and stop