IWR6843ISK-ODS: UART Interface validation

Anil Kumar23

Part Number: IWR6843ISK-ODS
Other Parts Discussed in Thread: IWR6843

Hi Team,

I have implemented the interface validation code of UART loopback and CAN by taking the reference from mmWave SDK. May I know how to run the validation test after loading the binary file to iwr6843?

Regards,

Anil

over 6 years ago

0 Justin Curewitz over 6 years ago

TI__Mastermind 28055 points

Hi Anil,

I will check with an SDK developer and get back to you.

Regards,

Justin

0 Justin Curewitz over 6 years ago in reply to Justin Curewitz

TI__Mastermind 28055 points

Hi Anil,

You will need to run the device in debug mode, and load the test code for debug. Then the console will output instructions to run the test.

regards,
Justin

0 Anil Kumar23 over 6 years ago in reply to Justin Curewitz

Expert 1210 points

Hi Justin,

Thanks for the reply.

In our custom design board, we don't have JTAG support for connecting it to CCS.

Is there any privilege to run the code from the uart console?

Regards,

Anil

0 Justin Curewitz over 6 years ago in reply to Anil Kumar23

TI__Mastermind 28055 points

Hi Anil,

The UART test can only be run in debug mode.

Regards,
Justin

0 Anil Kumar23 over 6 years ago in reply to Justin Curewitz

Expert 1210 points

Hi Justin,

Thanks for the reply.Issue is solved.

Regards,

Anil

Sensors

Sensors forum

IWR6843ISK-ODS: UART Interface validation