CCS/AWR1642BOOST: How to set the parameters of CQSigImgMonitor and CQRxSatMonitor in profile ?

user5297696

Part Number: AWR1642BOOST
Other Parts Discussed in Thread: AWR1642, AWR1843

Tool/software: Code Composer Studio

I modified the chrip info of profile_2d_srr.cfg in C:\ti\mmwave_sdk_02_01_00_04\packages\ti\demo\xwr16xx\mmw\profiles as below:

profileCfg 0 77 4 5 39 0 0 17.688 1 212 6250 0 0 30

while the CQSigImgMonitor must be disalbed (analogMonitor 1 0 or analogMonitor 0 0) then the radar can work;

So how to set the CQRxSatMonitor and CQSigImgMonitor parameters?

over 6 years ago

0 user5297696 over 6 years ago

Intellectual 435 points

The console message from demo vesualizer CLI is as below:

mmwDemo:/>DSS Exception: dss/dss_data_path.c, line 1588.

MSS Exception: mss/mss_main.c, line 2111.

And I fond in mmwaveSDK v3.1.1.2, analogMonitor command is canceled, why?

0 Jitendra Gupta over 6 years ago in reply to user5297696

TI__Guru 69960 points

Hi,

SDK 3.1 is for AWR1843. You better try SDK 3.2 which has this CLI command for AWR1642

Regards,

Jitendra

0 user5297696 over 6 years ago in reply to Jitendra Gupta

Intellectual 435 points

Dear Jitendra

I modified the chrip info of profile_2d_srr.cfg in C:\ti\mmwave_sdk_02_01_00_04\packages\ti\demo\xwr16xx\mmw\profiles as below:

profileCfg 0 77 4 5 39 0 0 17.688 1 212 6250 0 0 30

while the CQSigImgMonitor must be disalbed (analogMonitor 1 0 or analogMonitor 0 0) then the radar can work;

could you tell me how to set the CQRxSatMonitor and CQSigImgMonitor parameters?

0 Jitendra Gupta over 6 years ago in reply to user5297696

TI__Guru 69960 points

Hi,

Please refer mmwavelink test application (ti/control/mmwavelink\test) for reference of using CQ monitoring rlRfRxIfSatMonConfig and rlRfRxSigImgMonConfig APIs.

Above CLI commands uses these mmwavelink APIs only.

In this test application, it uses direct API.

Regards,

Jitendra

Sensors

Sensors forum

CCS/AWR1642BOOST: How to set the parameters of CQSigImgMonitor and CQRxSatMonitor in profile ?