I bought a board of DCA1000EVM, but when I connect with the PC, show the following :
a. Uninstall HSDC Pro
b. Install it again while TSW1400 board is connected through USB
c. Re-launch the mmWaveStudio GUI
I try the b&C,but it didn't work , I don't know how to Unistall HSDC Pro,Please tell me the details
Hi,
This error message is usually received when the FTDI drivers are not correctly installed.
Could you please try uninstalling and re-installing the FTDI drivers again. The WHQL drivers from FTDI's website should be good enough.
Please refer to a similar thread on this topic that was recently resolved:
Best Regards,
Anand
