TMP103: Minimum fall time

Russell Wetherley1

Expert 4255 points

Part Number: TMP103
Other Parts Discussed in Thread: TMP108

Hello E2E,

I am assuming no, but is there a minimum fall time for I2C lines on the TMP103? Just want to check. Thanks!

Russell

over 6 years ago

0 Russell Wetherley1 over 6 years ago

TI__Expert 4255 points

Also, what about for TMP108?

Thanks!

Russell

0 Brandon Fisher94 over 6 years ago in reply to Russell Wetherley1

TI__Mastermind 28075 points

The answer for both the TMP108 and TMP103 is that they don't have a minimum fall time specification. I2C standard does however specify a minimum fall time for fast mode and fast-mode plus, so if you want to assume a minimum you could use this. You may also want to check that your I2C master does not have a minimum fall time spec.

Best Regards,
Brandon Fisher

Sensors

Sensors forum

TMP103: Minimum fall time