AWR1243: How to use Advanced Frame Config Tab operations in mmWave Stugio 1.0.0.0

user6022435

Part Number: AWR1243

Hi Team

When I would like to use subframe of function,is this follow procedure correct?

For previous procedures, I refer to "mmWave Sensor Raw Data Capture Using the DCA1000 Board and mmWave Studioproccedure" .

fig1 setting1

fig2 setting2

fig3 start testing

0 Jitendra Gupta over 6 years ago

Hi,

I can't see any image here.

Based on your other thread, adv-frame configuration is correct.

Are you facing any issue while configuration and capturing the data?

Regards,

Jitendra

0 Vivek Dham over 6 years ago in reply to Jitendra Gupta

Hello ,

Am temporarily closing this thread due to inactivity. You can just reply on this thread and it would re-open.

regards,
Vivek

Sensors forum