MMWCAS-DSP-EVM: matlab version

Katsuhiro Miyamoto

Part Number: MMWCAS-DSP-EVM

Hello support team,

Which version of matlab license, toolbox and option is required to run post-processing then to display processed data as shown in the figure of 8.3.2.3 Post-processing and the figure of 8.3.3.2 Steps to process the capture data and etc? These figures and sections are in mmWave Studio Cascade User's Guide.

Best Regards,
Katsuhiro

over 5 years ago

0 Cesar over 5 years ago

TI__Guru*** 149044 points

Hi,

WIll check with SW team and will get back to you

thank you

Cesar

0 Cesar over 5 years ago in reply to Cesar

TI__Guru*** 149044 points

Hi,

The Matlab version should not matter. We tried 2014, 2016, 2017, 2018 with no problems

thank you

Cesar

0 Katsuhiro Miyamoto over 5 years ago in reply to Cesar

Expert 1460 points

Hi Cesar,

Understood. Thank you very much.
Is any of toolbox, for example Signal Processing Toolbox, Phased Array System Toolbox required, or any of toolbox is not required?

Best Regards,
Katsuhiro

0 Cesar over 5 years ago

TI__Guru*** 149044 points

No toolbox requiref

0 Katsuhiro Miyamoto over 5 years ago in reply to Cesar

Expert 1460 points

Hi Cesar,

I see.
Thanks a lot.
Katsuhiro

0 Katsuhiro Miyamoto over 5 years ago in reply to Katsuhiro Miyamoto

Expert 1460 points

Hi,

I got evaluation license and confirmed that:
MIMO LUA script requires matlab and signal processing toolbox,
TX Beamforming LUA script requires only matlab.

Just for your information.

Thanks,
Katsuhiro

Sensors

Sensors forum

MMWCAS-DSP-EVM: matlab version