Hello everyone,
I am trying to use an LDC1314 through my Launchpad F28379D using Matlab Embedded Coder.
I can succesfully send information to be written to the registers.
Nevertheless, whenever I try to read something (ie RCOUNT0 register, subsystem at the right), the program will keep sending the attached signal (which I obtained with the oscilloscope).
According to me, it is just trying to read, thus missing the FRAME 1 and FRAME 2 that correspond to what should have been transmitted before the reading sequence.
Any suggestions? Here you can see my simulink 'read' subsystem.
Thank you very much in advance,
Patricio