IWR1443: Qustion of relate to radiation of CW

user6022435

Part Number: IWR1443

I woukd like to measure IWR1443's Tx power, using spectrum analizer.

To measure this, IWR1443 always needs to radiate CW.

I guess that IWR1443 can always radiate CW using "Constream" tab of mmWavestudio.
Is the following recognation correct?

Plus, how do I this? Is the below way right?

IWR1443 starts to radiate CW when I push "Enable" button of "Stream Enable" after I set "Streamconfig".

0 CHETHAN KUMAR Y.B. over 5 years ago

Hello user6022435,

Yes your outline is correct, Prior to that I guess you have done the boot mode configuration and firmware loading.

are you facing any problem? If yes, post your logs from the mmWave studio.

Thanks and regards,

CHETHAN KUMAR Y.B.

0 user6022435 over 5 years ago in reply to CHETHAN KUMAR Y.B.

Hi, CHETHAN KUMAR Y.B.

Thank you reply.

It has been become clearly what I would like to know.

Sensors forum