AWR2243: AWR2243 Cascade Data Capture

Hi,

The data is received by the host. The host firmware decides to capture or discard the data.

Thank you

Cesar

yes, but what are the conditions to capture or discard?

They are defined by the sw developer.

For the TI cascade kit, all the data received by the host is captured. The stream of date is directed to the SSD

Thank you

Cesar

yes i know this, but what are the conditions to collect the data is it based on a counter or a specific signal? what signals are needed to collect data

Hi Glen, 

For the CSI2 interface only the data and clock signals are necessary. MIPI-CSI2 contains its own frame start/stop packets that tell the host receiver when to start receiving data. Is that what you are asking about, or something else?

Thank you,

-Randy

we were able to get data out of the rf board and into an external fpga board, however we are not detecting a target in different locations no matter if a corner refector is present of even putting material directly in front of the antennas. is there some sort of loop back that needs to be disabled or what would cause this targets to not be seen internally?

Thank you