Hi, I would like to make a breakout board for the IWR6843ISK using the high density connector (QTH-030-01-L-D-A) (J4 and J17) present on the MMWAVEICBOOST. May I know where to get the details of the spacing between J4 and J17 that fits the IWR6843ISK?
Hello,
Please find the distance information between the two connector shown below.
However, we would strongly recommend to to down load the EVM database from the below link from the below design package and perform connector mating arraignment.
https://www.ti.com/tool/MMWAVEICBOOST
Design package for the mmWaveICBOOST carrier board.
https://www.ti.com/lit/zip/swrc355
It's important to get a aliment for the footprint on the mating connectors, Hence it's recommended to overlap the interface board with J4 and J17 connectors.
Thanks and regards,
CHETHAN KUMAR Y.B.
