IWR6843ISK: Issue in Designed Advanced chirp configuration, Not receiving frames from RADAR device

Shraddha Swami

Part Number: IWR6843ISK

Hi TI Team,

We are working on area scanner zone application from TI industrial Toolbox, we designed our advanced chirp profile for IWR6843ISK + MMWAVEICBOOST device. We are sending this configuration to device but we are not receiving any frames from the RADAR. Please find the attached config file.

May i learn the issue in config file ?

Could you please assist on the same?

Thanks 2768.areascanneriwr6843advfrm.cfg

over 5 years ago

0 Akash Gondalia over 5 years ago

TI__Guru 50240 points

Hi Shraddha

We'll need more information in order to assist you.

Is the device reporting any kind of error? Are you running this in debug mode?

Also is there a separate working chirp configuration you have been using?

Regards,

0 Yogesh Siraswar over 5 years ago in reply to Akash Gondalia

TI__Mastermind 20755 points

Hi Shraddha,

We are running out of heap memory. Could you please provide some back-ground on how you are designing the chirp. Also seems you are not using tracking or static detection. Will you be needing that?

Thanks

Yogesh

0 Shraddha Swami over 5 years ago in reply to Yogesh Siraswar

Intellectual 370 points

Hi Yogesh,

Thanks for your response. We rectified the issue, that was occurred due to those missing tracking and static configurations.

Thanks

Sensors

Sensors forum

IWR6843ISK: Issue in Designed Advanced chirp configuration, Not receiving frames from RADAR device