AWR1243BOOST: How to sync up local oscillators

Kawaguchi

Part Number: AWR1243BOOST
Other Parts Discussed in Thread: AWR1243

Hi Team,

I would like to inquire about how to sync up local oscillators of AWR1243BOOSTs.

I am trying to realize the sensing which uses two boards simultaneously with two AWR1243BOOSTs as shown in the illustration below.

I would like to do sensing and achieve a raw data with the configuration.

However, the LOs of each board need to be synced up to realize the configuration.

How can I achieve the synchronization of the LOs? I am looking forward to your reply.

Best regards,

Kawaguchi

0 Ishita Kochar over 5 years ago

Hello Kawaguchi-San,

Please refer to this AWR2243 cascade application note. This is applicable for AWR1243 as well.

Regards,

Ishita

0 Kawaguchi over 4 years ago in reply to Ishita Kochar

Hi Ishita san,

thank you for your reply. I am checking the application note and doing some trials. If I have additional questions, I will make a new thread.

Best regards,

Kawaguchi

Sensors forum