AWR1843BOOST: How can I get the parameters of AWR1843BOOST

AJ Chen

Prodigy 10 points

Part Number: AWR1843BOOST

Hi team,

Recently, I am using AWR1843BOOST for research. I would like to know about some specific parameters of AWR1843BOOST:

range，azimuth and elevation field of view
number of range, azimuth and elevation bins in the output of radar
resolution of azimuth and elevation
FMCW sweep time
Baseband sampling rate
antenna element spacing, including the space between TX antenna and RX antenna, and the value of lambda in the picture

Could you give us some suggestions about this issue ?

Thank you.

Anjun Chen

over 4 years ago

0 Ishita Kochar over 4 years ago

TI__Mastermind 31680 points

Hello Anjun,

All your concerns are answered in our device collateral documents or addressed by our experts for some previously answered threads on this forum.

I request you to search for some similar threads and refer to our boost user guides and the device Datasheet. I'm also attaching some links below for your reference :

https://e2e.ti.com/support/sensors/f/1023/t/821174

AWR1843BOOST and IWR1843BOOST Single-Chip mmWave Sensing Solution User's Guide (Section 2.7)

AWR1843 Single-Chip 77- to 79-GHz FMCW Radar Sensor datasheet (Rev. B)

FMCW sweep time depends on the chirp configuration parameters : Programming Chirp Parameters in TI Radar Devices

Let us know if you need any further clarification.

Regards,

Ishita

Sensors

Sensors forum

AWR1843BOOST: How can I get the parameters of AWR1843BOOST