MMWCAS-DSP-EVM: How to confirm the revision No.

Cruijff

Part Number: MMWCAS-DSP-EVM
Other Parts Discussed in Thread: MMWCAS-RF-EVM,

Hi community member,

I have a favor to ask.
According to our board, it is written "PROCO55E6".
Is it correct the board revision is E6?

We would like to test MMWCAS-RF-EVM(AWR2243P).
According to mmwave-studio-cascade.pdf, it needs revision E4 or later board.

Best regards.
Cruijff

over 4 years ago

0 Cesar over 4 years ago

TI__Guru*** 149104 points

Hi,

When was the board purchased?

If it was purchased in the last 6 months, for sure it is a board with AWR2243P

Thank you
Cesar

0 Cruijff over 4 years ago in reply to Cesar

Expert 2760 points

Hi Cesar,

We will order MMWCAS-RF-EVM(AWR2243P) in near future.

We want to know our MMWCAS-DSP-EVM's revision.
If this EVM is older E3 or earlier, I think it can't operate using AWR2243P's cascade EVM according to User's Guide.

So we need to check our revision.
I took a picture of our board.
Is it correct this EVM is E6 revision?

Best regards.
Cruijff

0 Ishita Kochar over 4 years ago in reply to Cruijff

TI__Mastermind 31680 points

Hello Cruijff,

Yes, you are right. This is E6 revision, and it should be fine.

Regards,

Ishita

0 Cruijff over 4 years ago in reply to Ishita Kochar

Expert 2760 points

Hi Ishita,

I see!
I knew that our EVM revision is "E6".

Thanks!

Cruijff

Sensors

Sensors forum

MMWCAS-DSP-EVM: How to confirm the revision No.