PGA900: PGA900 EVM and PGA900 GUI

GibsonR8

Part Number: PGA900

When I debug PGA900 with CCS and PGA900 GUI,if I click start button inPGA900 GUI ADC Capture,CCS will occur error message.And I can't debug again,must power off PGA900 EVM and power on again.

If anyone happend the same problem,and how to solve?

over 4 years ago

0 Scott Cummins over 4 years ago

TI__Mastermind 31655 points

Hello,

When in debug mode, you are running the firmware on the PGA900, disabling communication through the digital interfaces. The GUI communicates through the digital interfaces and you have to place the internal M0 into reset to read any data, including using the ADC capture. Placing the M0 in reset will pull it out of debug mode. You will not be able to use the GUI and run the PGA900 in debug mode at the same time.

Regards,

0 GibsonR8 over 4 years ago in reply to Scott Cummins

Prodigy 220 points

OK i see, thanks a lot

Sensors

Sensors forum

PGA900: PGA900 EVM and PGA900 GUI