AWR1843BOOST: ODOC Lab for AWR1843 Boost Board

Shankar Nagarajan

Intellectual 275 points

Part Number: AWR1843BOOST
Other Parts Discussed in Thread: AWR1843, AWR1642

Hi,

I have tried CAN SBL Lab on AWR1843 Boost Board. I can able to transfer the image using CANFD.

Similarly, I want to work on ODOC Lab on AWR1843 Boost Board. But it is available for AWR1642.

Is there any way to get the Project Spec File/Standalone Code for ODOC Lab working on AWR1843 Boost Board?

Regards,

Shankar.N

over 4 years ago

0 Cesar over 4 years ago

TI__Guru*** 147964 points

Hi,

Yes, this is possible

Please see mmWave FAQ Q21

Thank you

Cesar

0 Shankar Nagarajan over 4 years ago in reply to Cesar

Intellectual 275 points

Hi,

Thanks for the update.

I will go through that.

Regards,

Shankar.N

0 Cesar over 4 years ago in reply to Shankar Nagarajan

TI__Guru*** 147964 points

Thank you

Cesar

0 Shankar Nagarajan over 4 years ago in reply to Cesar

Intellectual 275 points

Hi,

Thank you for sharing the FAQ Link.

Can i get any ODOC reference codes which works on AWR1843 Boost?

Regards,

Shankar.N

0 Cesar over 4 years ago in reply to Shankar Nagarajan

TI__Guru*** 147964 points

Hi,

This lab is based on the xWR16xx mmWave SDK OOB demo. The only update was to change the output from UART to CAN.

By following the directions in the mmWave FAQ you will be able to run this code on AWR1843. However it will still use only 2 Tx antenna in the same way as xWR16xx.

If you wish you can take the xWR18xx mmWave SDK OOB demo and modify it to support CAN

Thank you

Cesar

0 Shankar Nagarajan over 4 years ago in reply to Cesar

Intellectual 275 points

Thanks.

Regards,

Shankar.N

Sensors

Sensors forum

AWR1843BOOST: ODOC Lab for AWR1843 Boost Board