AWR6843AOP: pinmux header in the SDK does not have some pins of AOP device

Hi,

The pin config tool does not work for this? Can you please confirm what peripheral needs to be configured?

Regards,

Hi Charles,

With SysConfig (v1.7.01746), when adding CANFD pins (Rx:B3 and Tx:C3) , below pin mux code was generated in pin_mux_config.c file.

// Pinmux_Set_OverrideCtrl(SOC_XWR68XX_PINB3_, PINMUX_OUTEN_RETAIN_HW_CTRL, PINMUX_INPEN_RETAIN_HW_CTRL);
Pinmux_Set_FuncSel(SOC_XWR68XX_PINB3_,SOC_XWR68XX_PINB3__CANFD_RX);

// Pinmux_Set_OverrideCtrl(SOC_XWR68XX_PINC3_, PINMUX_OUTEN_RETAIN_HW_CTRL, PINMUX_INPEN_RETAIN_HW_CTRL);
Pinmux_Set_FuncSel(SOC_XWR68XX_PINC3_,SOC_XWR68XX_PINC3__CANFD_TX);

However, in pinmux.h (in the SDK v3.05), there is no definition of pins for the AOP as below.

   - SOC_XWR68XX_PINB3_

   - SOC_XWR68XX_PINC3_

So, where can I find "pinmux.h" for AOP device?

Regards,

Hayden

Hi,

I will get back to you on this after getting feedback from the subject matter expert.

Regards,

Charles O

From data sheet, AWR6843AOP has more GPIO pins than AWR6843.

In the SDK, there is no pins of GPIO_39 ~ GPIO_46, it is required to add the pins (ball name).

So, do you have any patch of pinmux_xwr68xx.h for the additional pins?

Hi,

This issue is being worked on internally, I will provide the feedback once its completed.

Regards,

Charles O