• State Resolved
  • Locked Locked
  • Replies 4 replies
  • Answers 1 answer
  • Subscribers 34 subscribers
  • Views 2223 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

TDC-1000-TDC7200 new firmware.

Sunny Shin
Prodigy 20 points

Other Parts Discussed in Thread: TDC1000

I got the evm last week.

I intalled the GUI software and run it.


I see the pop-up like this.


So I goto the debug menu for update the firmware.


But I can't find a new firmware at your homepage.


How can i get the new virsion?

  • 0
    TI__Expert 4725 points
    Sunny,
    The firmware can be found at C:\Program Files (x86)\Texas Instruments\TDC1000_7200EVM\Firmware

    I deleted the 3 other posts you entered with the same issue.

    regards,
  • 0
    Prodigy 20 points

    I received the answer.

    So I try again, but it doesn’t work.

    See below.

     

    What’s the next step?

  • 0 in reply to Sunny Shin
    TI__Mastermind 21685 points

    May be the security settings of your PC is not allowing the firmware upgrade application to come up. You can access this application directly as explained below:

    a) In the following install folder

    C:\Program Files (x86)\Texas Instruments\TDC1000_7200EVM\MSP430 USB Firmware Upgrade Example

    there's an application called "BSL_USB_GUI.exe".

    Please invoke this application and use it to upgrade the firmware.

    b) You should disconnect and reconnect the EVM while holding the SW1 button down so the MSP430 device is in BSL mode for firmware upgrade. You should see the "Found 1 device" message as shown in the screen capture below.

    c) Then browse and choose the firmware hex file "TDC1000_7200_FW-v2.01-1MHz.txt" from the install folder

    C:\Program Files (x86)\Texas Instruments\TDC1000_7200EVM\Firmware

    and press "Upgrade Firmware"

    Thanks,

    Vishy

  • 0 in reply to Vishy Viswanathan
    Prodigy 145 points

    I have followed these instructions and tried to update the relevant hex file. However the firmware always fails to update and gives the following message: "Failed to read data from RAM BSL". How should I proceed