Tool/software:
Hi Team,
Could you please provide S-Parameter of part number "TS3DDR4000"
Regards,
Abdul Wahaj Khan
R&D Altanova
Component Engineer
Tool/software:
Hi Team,
Could you please provide S-Parameter of part number "TS3DDR4000"
Regards,
Abdul Wahaj Khan
R&D Altanova
Component Engineer
Hello Abdul,
Please look at this e2e thread where a s parameter file is created and available for you use!
Please let me know if you have any additional questions!
Regards,
Kameron
Hi Kameron,
I can not find any S-parameter file on this thread. May be this thread is expire before I've check this.
Please send me the s-parameter file so it will be helpful for me.
Regards,
Abdul Wahaj Khan
Hello Abdul,
Understood! Here is the s parameter file.
Please let me know if this works for you and I am happy to helpTS3DDR4000_FULL (2) (1).zip
Regards,
Kameron
Hi Kameron,
I can see the data. But we didn’t know the port definitions in this file. From the IC block diagram, there have A0~A11, B0~B11 and C0~C11.
Please help for the port definition for the touchstone file and what’s the condition (SEL0=? | SEL1=?) as well. Thank you.
Regards,
Abdul Wahaj Khan
Hello Abdul,
So the port mapping for this device is as follows
Port1= On channel Source (B0)
Port2= Off-channel Source (C0)
Port3= On channel Drain (A0)
Port4= On channel Source (B1)
Port5= Off-channel Source (C1)
Port6= On channel Drain (A1)
And this pattern will repeat all they way down to the last group of pins A11,B11,C11
Also the state of the multiplexer is all of the control pins are low.
SEL0=Low | SEL1=Low and eanble is low as well.
Please let me know if there are any other issues with the model and I am happy to help!
Regards,
kameron
Hi Kameron,
Thanks! The results are EN to B.
Could you please help for EN to C ? or the results are the same as EN to B.
Regards,
Abdul Wahaj Khan