TS5A22362: Confirmation on Pin marking and orientation in tape cavity

Cameron Wutzke

Part Number: TS5A22362

Tool/software:

Datasheet page 24 appears ball A3 is marked... is that true? I expect ball A1 to be marked

And could you please confirm how the BGA package will sit inside the tape?

since pin 1 location in the tape cavity is Q2, this lays the part horizontally in the cavity, when they usually seem to be vertical:

5 months ago

0 Kameron Hill 5 months ago

TI__Mastermind 24440 points

Hey Cameron,

I confirmed with our internal team that the top side marking for this device will be at pin 1(top left) and not at the a3 location on the datasheet

In addition I can also confirm with our internal systems that Q2 is pin 1 of the device and the part will be horizontal in the cavity

Please let me know if this helps and I can look into this further.

Regards,

Kameron

0 Cameron Wutzke 5 months ago in reply to Kameron Hill

TI__Expert 3592 points

Kameron Hill said:
In addition I can also confirm with our internal systems that Q2 is pin 1 of the device and the part will be horizontal in the cavity

Yes please! This would be helpful

0 Kameron Hill 5 months ago in reply to Cameron Wutzke

TI__Mastermind 24440 points

Hey Cameron

apologies as I mis spoke

q2 is pin 1 of this device based on the internal Ti info I looked at

Regards,

Kameron

Switches & multiplexers

Switches & multiplexers forum

TS5A22362: Confirmation on Pin marking and orientation in tape cavity