Texas Instruments XDS200 USB Debug Probe from balckhawk can not flash image

HL P

I used Texas Instruments XDS200 USB Debug Probe from balckhawk to flash image, but reported ERROR 2083.

But on the another PC, I used Texas Instruments XDS200 USB Debug probe from Spectrum Digital to flash image. it successes.

I check CCS IDE Verion and XDS200 version, it is same.

So what makes it flash failed with blackhawk XDS200?

over 4 years ago

0 HL P over 4 years ago

Prodigy 40 points

Here is error message

0 Ki over 4 years ago in reply to HL P

TI__Guru**** 483361 points

Hello,

This error is known as a type of "host connection error". Basically the PC is having issues communicating with the debug probe.

The reasons for the error can vary greatly. See the below link for more details:

https://software-dl.ti.com/ccs/esd/documents/ccs_debugging_jtag_connectivity_issues.html

Based on your description, it sounds like you have one blackhawk XDS200 connected to one PC and one spectrum digital XDS200 connected to another PC. The PC with the spectrum digital XDS200 works fine while the setup with the blackhawk does not. If you take that spectrum digital XDS200 and try using it with the PC that is having issues with the blackhawk, does it still work?

Thanks

Code Composer Studio™︎

Code Composer Studio forum

Texas Instruments XDS200 USB Debug Probe from balckhawk can not flash image