using sysconfig utility with am243x

Eli Mordel

Expert 1385 points

Other Parts Discussed in Thread: SYSCONFIG

Hi,

I'm writing a project for the am243x using sysconfig utility.

I've added UART but then got an error: #include <drivers/uart/v0/dma/uart_dma.h> - file not found

Please advice on how to proceed.

Is there a tutorial on how to use sysconfig utility ?

Thanks,

Eli.

over 2 years ago

0 Ming Wei over 2 years ago

TI__Guru 56265 points

Hi Eli,

Are you adding the UART via the syscfg file in CCS project? There are some paths need to be set properly for the sysconfig to work properly. The easiest way to do this is to start with the empty project, then add your peripherals and application code into it. Assuming that you have installed the MCU+ SDK at C:\ti location (by default).

Please refer to the following URL for syscfg tutorial:

AM243x MCU+ SDK: Using SDK with SysConfig (ti.com)

Best regards,

Ming

0 Eli Mordel over 2 years ago in reply to Ming Wei

Expert 1385 points

Hi Ming,

Thanks for the info !

I was looking for some video tutorial because the sysconfig is very complicated.

Code Composer Studio™︎

Code Composer Studio forum

using sysconfig utility with am243x