Error connecting to target in ccs5

prat

Other Parts Discussed in Thread: OMAP-L138

Hi,

I am getting an connecting to either arm or dsp of omap-l138 in ccs5.1. projecxt is sys/bios.

I show the screen shot here. Whereas my board, from logicPD, is always connected and turned on, xds100v2 cable is intact.

whats is Any fix for this issue?

regards,

Prat

over 14 years ago

AartiG over 14 years ago

TI__Guru**** 173310 points

Prat,

Is this a board that you have previously been able to connect to? I can't see the exact error code very well in your screenshot, but please see these related threads and see if they help you?

http://e2e.ti.com/support/development_tools/code_composer_studio/f/81/p/69140/250246.aspx#250246
http://e2e.ti.com/support/development_tools/code_composer_studio/f/81/p/108925/393556.aspx#393556

prat over 14 years ago in reply to AartiG

Expert 1115 points

Hello ArtiG,

This problem seems to be intermittent.

I tried, several times, by deleting/removing target configuration files and then creating new/re-connecting but none of them working.

I have to exit CCS, turn-off the board, disconnect the USB cable, re-connect USB, turn-on board and launch CCS. Then do the normal process.

Can you provide an easier solution for this?

Regards,

Prat

Code Composer Studio™︎

Code Composer Studio forum

Error connecting to target in ccs5