j-link error JLINKARM_IsHalted()

Dennis Begun

Other Parts Discussed in Thread: SEGGER

I follow the steps here: http://processors.wiki.ti.com/index.php/J-Link_Emulator_Support

When I run the configuration file I get the output:

CORTEX_M3_0: GEL Output:
Memory Map Initialization Complete
CORTEX_M3_0: Error: Stat [ JLINKARM_IsHalted() call ] failed!

Any suggestions?

Thank you.

over 13 years ago

0 Victor Yang over 13 years ago

TI__Expert 4150 points

Hi Dennis,

Which device are you using? And which version of the J-Link install pack? v0.1.0.2 only supports CCS 5.2.0 onwards.

Also, you can test the connection of your setup by using the command line tool JLink.exe from Segger @ http://www.segger.com/jlink-software.html. Please check if you can connect to the device first.

Regards,

Victor Yang

0 Dennis Begun over 13 years ago in reply to Victor Yang

Intellectual 825 points

My bad - I forgot to connect the right jumper. It works now.

0 Victor Yang over 13 years ago in reply to Dennis Begun

TI__Expert 4150 points

No problem. Please do not hesitate to contact us if you encounter other problems.

Code Composer Studio™︎

Code Composer Studio forum

j-link error JLINKARM_IsHalted()