• Locked Locked
  • Replies 4 replies
  • Subscribers 53 subscribers
  • Views 871 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Data verification failed at address 0x003F6000 Please verify target memory and memory map.

lei ge
Prodigy 90 points
Other Parts Discussed in Thread: TMS320F28027

I use the TI's developement_ kit of TMDSHVRESLLCKIT_v1.0,When I do the experiment and load the .out file to the TMS320F28027's flash.Then,the problem turns out:

C28xx: File Loader: Data verification failed at address 0x003F6000 Please verify target memory and memory map.
Error found during data verification.
Ensure the linker command file matches the memory map.
C28xx: Error: (Error -1135 @ 0x3FF5F5) The emulator reported an error. Confirm emulator configuration and connections, reset the emulator, and retry the operation. (Release 5.0.333.0)

by the way: I use the software CCSV4.2.3. I meet this problem several times ,before I solve this problem by change the dsp chip TMS320F28027. But ,that's not a good idea,wast money and troublesome. So.I want to someone give me some advices and help me solve this problem.Thank you very much!

  • TI__Guru*** 130875 points

    Hi Lei,

    did you check that you are using the correct linker command file for the project/setup?  Can you provide a bit further details?  Was there something specific you meant when you said you have corrected a similar problem by changing the chip? 

    It looks like there might be conflicting memory configurations.

    Best Regards,
    Lisa

  • in reply to Lisa TI
    Prodigy 90 points

    Hi Lisa,

    I just used the example file of the Ti development_kits TMDSHVRESLLCKIT_v1.0.

    I did not change nothing,but the problem happened.

    I heared that someone said the CCSv5 is good than CCSV4.2.3. If change the compile software ,then the problem will not

    happen. But unfortunately that also does not work.I am so puzzled.

    Regards,

    Ge Lei

  • in reply to lei ge
    TI__Guru*** 130875 points

    Hi Ge Lei,

    have you tried CCSv5?  Have you upgraded your v4 to 4.2.5?  Please give this a try, especially if it was recommended.

    How did you load/import the example?   Do you know what platform the project is set to use?

    Best Regards,
    Lisa

  • in reply to Lisa TI
    TI__Guru*** 130875 points

    Hi Ge Lei,

    just wanted to check whether there was any update to your enquiry here.

    Best Regards,
    Lisa