Debugger Initalization Error using expOMAP-L138, XDS560V2 STM, CCS5.2.

Mike Geppert

Expert 1980 points

I have been upgrading CCS5.1 to 5.2 and it has not been going well. I finally deleated and did a reinstall and was able to build my projects.

Now I go to debug on a expOMAP-L138 and when I try to connect I get the following:

Can't generate board data file C:\DOCUME~1\bh44962\LOCALS~1\APPLIC~1\.TI\2620625255\0\1\BrdDat\ccBoard0.dat

An invalid processor ID has been found.

I did delete the .TI directory and try getting everything to rebuild itself and got the same error...

What to do?

over 13 years ago

0 Ki over 13 years ago

TI__Guru**** 476191 points

Hi Mike,

Could you try creating a new target configuration (*.ccxml) file with 5.2? I'm wondering if the ccxml file you had with 5.1 is causing some issue with 5.2.

Thanks

0 Mike Geppert over 13 years ago in reply to Ki

Expert 1980 points

I was just about to reply that is what I did and it worked!

Thanks so much...

0 Ki over 13 years ago in reply to Mike Geppert

TI__Guru**** 476191 points

Great! Would you mind attaching that ccxml from your 5.1 install that fails in 5.2? Just want to see what part of the file is causing the incompatibility

Thanks

0 Mike Geppert over 13 years ago in reply to Ki

Expert 1980 points

Sorry I dont seem to have it anymore...

Code Composer Studio™︎

Code Composer Studio forum

Debugger Initalization Error using expOMAP-L138, XDS560V2 STM, CCS5.2.