Runnint the target after disconnecting the debug session(doing something similar to a Power reset)

Manoj R

Hi,

I have several test case.out files.I need to flash each .out file(the test cases cannot run in debug mode) and after flashing the debug session needs to terminate and the target should start running.How can I achieve this using debug server scripting.

Regards

Manoj

over 12 years ago

Ki over 12 years ago

TI__Guru**** 483141 points

Hi Manoj,

You can probably just run loadti with the -a option (run asynchronously). This should leave the target running after the debug session is terminated.

http://processors.wiki.ti.com/index.php/Loadti

Thanks

Manoj R over 12 years ago in reply to Ki

TI__Intellectual 1595 points

Hi,

The execution stops with the termination of the debug session.The status update which i am printing on serial terminal stops after printing just small portion of the text.

Regards

Manoj

Ki over 12 years ago in reply to Manoj R

TI__Guru**** 483141 points

hmmm. you may have to do a run free. I'll look into this

Manoj R over 12 years ago in reply to Ki

TI__Intellectual 1595 points

Any updates.This is stopping us from implementing our test infrastructure.

Ki over 12 years ago in reply to Manoj R

TI__Guru**** 483141 points

Sorry for the delayed response. What exact device are you using?

Code Composer Studio™︎

Code Composer Studio forum

Runnint the target after disconnecting the debug session(doing something similar to a Power reset)