Simulink Code generation for C6657LS EVM

Vignesh Rajasekaran

Hi Everyone,

I have a C6657LS EVM board with integrated XDS200 Emulator. And I am using Matlab R2011a and Code Composer Studio Version 5.5.

I have never worked with an Eval board before. Currently I'm learning to work with one.

My target : To blink the 4 debug LEDs (FPGA_D1 to FPGA_D4) on the EVM board through Simulink + CCS v5.5.

My Attempt : I tried using the Simulink Embedded Coder library\ Embedded Targets\ Target Preferences block, but could not find the "C6657" under the 'processor list'.

I kindly request any of you to give me your suggestion on how I could proceed to achieve my target. Thanks in advance.

Regards,

Vignesh

over 11 years ago

0 Raja over 11 years ago

TI__Guru* 81335 points

Hi Vignesh,

I have moved this thread over to the CCS forum in hopes that you will get a faster response there.

Thanks.

0 Ki over 11 years ago

TI__Guru**** 465911 points

Hello Vignesh,

It is best to contact Mathworks directly for support on this particular issue.

Thanks

0 Vignesh Rajasekaran over 11 years ago in reply to Ki

Prodigy 20 points

Thanks Ki and Rajasekaran, for your reponses.

As per your suggestion, I will contact Mathworks.

Code Composer Studio™︎

Code Composer Studio forum

Simulink Code generation for C6657LS EVM