install J-Link support for CCS 5.2

SERINA DRS

Prodigy 170 points

hi All,

i use CCS V 5.2 and i want to exploit j-link emulator of segger but my ccs version doesn't support j link soft ware .

my question is: can i install the j link sw for ccs v5.2 for windows 7 ?and what is the compatible version ?

thanks in advance.

over 11 years ago

0 Gautam Iyer over 11 years ago

Guru 192875 points

Hi Serine,

Here's the wiki link that might answer your query: processors.wiki.ti.com/.../J-Link_Emulator_Support

Regards,
Gautam

0 SERINA DRS over 11 years ago in reply to Gautam Iyer

Prodigy 170 points

Hi Gautam, thanks for your help, can i used j_link emulator with the pandaboard es , i don't found information about that in this wiki link.
Regards ,
Serrina.

0 desouza over 11 years ago in reply to SERINA DRS

TI__Guru**** 171729 points

Serrina,

Jlink supported device list does not show OMAP4460 (the device on Pandaboard ES). However, it shows OMAP4430 and therefore you can potentially try using this configuration.

www.segger.com/jlink_supported_devices.html

Despite CCS may allow creating a target configuration file with Segger's Jlink, the support ultimately depends on their device drivers.

Hope this helps,
Rafael

Code Composer Studio™︎

Code Composer Studio forum

install J-Link support for CCS 5.2