CCS debug/run panel icons are gray

Leo Dubrovsky

Prodigy 80 points

Other Parts Discussed in Thread: CONTROLSUITE, MOTORWARE

In CCS 6.1.0 debug/run icons are gray, not active. "Run to line" works.

over 10 years ago

0 Ki over 10 years ago

TI__Guru**** 451311 points

Hello Leo,
There are many potential causes for the issue you describe. Can you provide a screenshot of your CCS environment that shows the issue? This will help narrow down some of the causes.

Thanks
ki

0 Leo Dubrovsky over 10 years ago

Prodigy 80 points

Ki, the screenshot is below. The same with all targets and emulators. I think it happened after controlSUITE and motorware installation.

Ki, the screenshot is abowe

0 Ki over 10 years ago in reply to Leo Dubrovsky

TI__Guru**** 451311 points

I believe you are running into a known issue when using Simple mode.

There is workaround you can try in the thread below:
e2e.ti.com/.../1476768

This issue should also be fixed in the CCSv6.1.1 release that went live yesterday so you can updating to that if you wish.

Thanks
ki