Error connecting to the target c2000

Mongkol Phukhamdang

Other Parts Discussed in Thread: TMS320F28335, CONTROLSUITE

what happen?

Error connecting to the target:
(Error -1041 @ 0x0)
The emulator reported an error. Confirm emulator configuration and connections, reset the emulator, and retry the operation.
(Release 5.0.333.0)

I don'tunderstand ccs.4 not connect

I worry project last years is use TMS320f28335 and I live in Thailand . if i buy TMS320f28335 I will three month. I am serious

and Thank you for answer.

over 9 years ago

0 Gautam Iyer over 9 years ago

Guru 192875 points

Hi,

Is this a custom board or dev kit?

Regards,
Gautam

0 desouza over 9 years ago in reply to Gautam Iyer

TI__Guru**** 171094 points

Hi,

Can you check section 5.19 of the page below?
processors.wiki.ti.com/.../Debugging_JTAG_Connectivity_Problems

Regards,
Rafael

0 Mongkol Phukhamdang over 9 years ago in reply to Gautam Iyer

Prodigy 80 points

HI ,

Development Kit .

The last about 2 weeks .I Test LED BLINK Software and Hardware is OK but now Error connect and i don't understand .

Could you please help me. I just bought 2 weeks

0 Mongkol Phukhamdang over 9 years ago in reply to desouza

Prodigy 80 points

Hi,
I don't have Jtag . What do you think is probleam . I felling fail is broad TMS320 Deverlop Kit
I just brouge 2 Week ago and I just test LED Blink . Cloud you please help me ?

0 Gautam Iyer over 9 years ago in reply to Mongkol Phukhamdang

Guru 192875 points

Why don't you check with CCS v6.1.1? Also, check your switch settings on the F28335 controlCard. Go through "F28335 controlCARD-InfoSheet" that can be found here: C:\ti\controlSUITE\development_kits\~controlCARDs\CC2833xHWdevPkg

Code Composer Studio™︎

Code Composer Studio forum

Error connecting to the target c2000