Creating TI RTOS project creation using CCS 6.1.1 for MSP430F5659 controller

Hello,
Your screenshot did not come through. You may want to try again.

In any case, I strongly recommend you visit the the below link for more information on how to get started with TI-RTOS. There is a section regarding using CCS with TI-RTOS:
processors.wiki.ti.com/.../Introduction_to_the_TI-RTOS_Kernel_Workshop

Thanks
ki

Nitesh Padiyar52 said:

I am working on MSP430F5659 controller. i want to use the TI RTOS. So how to create the new TI RTOS project using CCS 6.1.1.

As of TI-RTOS for MSP43x v2.14.03.28, only a subset of devices allow creation of TI-RTOS projects using the CCS.

According to Creating TI-RTOS Projects for Other MSP430 Devices you have to create a new TI-RTOS project in CCS for a supported device, MSP430FR5969 in your case, and then change the new project to use the actual target device. The referenced Wiki page explains how to do that. 

Hi,

Thanks for the input, but i have a question by changing target will my board.h file changes if not whether it needs manual editing?

Even other specific .h files for the device needs to be changed. i am referring to msp430f5529LP.h files of the example project.

Please guide me.

Nitesh

Hi,

I am working on ADC example code for battery monitoring for MSP430F5659, now i want to integrate USB CDC ( c4_packetProtocol) example but i got error saying descriptor.h not found. I have added all the folder including USB Config folder where descriptor file is available.

How to resolve this. Any build config need changes ?

Nitesh  

Hi Nitesh,
Your last question is likely best asked in the MSP forums. The experts there can likely help you best.

Thanks
ki