I cannot see address information during debug in Expressions view

Jiang Boqian

Hi there,

I am using Tiva launchpad for debugging. I found that there is no register's address information during debug in Expressions view, like the picture below:

I tried to find this setting in Preferences, however, with no luck...

How can I get the Address columns to display the corresponding register's address, I have seen this in forum like this below:

Thank you.

over 9 years ago

0 AartiG over 9 years ago

TI__Guru**** 173310 points

Jiang Boqian said:
I found that there is no register's address information during debug in Expressions view, like the picture below:

I assume you are selecting the register in the Registers view, right-clicking on it and selecting "Watch". Can you instead try adding it directly to the Expressions view (click on the Add new Expression and add GPIO_PORTA_AHB)? Does that help?

0 Jiang Boqian over 9 years ago in reply to AartiG

Intellectual 655 points

Thank you AartiG, it helps. So if I want to see register's address, I can only add it manually by typing it directly in Expressions view?
Another question, can I see register's address in Register view? However, I see no address column in Register view...

0 AartiG over 9 years ago in reply to Jiang Boqian

TI__Guru**** 173310 points

Jiang Boqian said:
So if I want to see register's address, I can only add it manually by typing it directly in Expressions view?

Yes that appears to be the only way.

Jiang Boqian said:
can I see register's address in Register view?

Sorry, no. The Registers view does not have an Address column to display.

0 Jiang Boqian over 9 years ago in reply to AartiG

Intellectual 655 points

Thanks for sharing the great information!

Code Composer Studio™︎

Code Composer Studio forum

I cannot see address information during debug in Expressions view