• State Resolved
  • Locked Locked
  • Replies 2 replies
  • Subscribers 53 subscribers
  • Views 561 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Error with Code Composer 3.3 and Matlab/Simulink 2008a

Carlos Alberto Ortega Huembes
Prodigy 30 points


Hi Guys,

I am new to DSP, I just got TMS320C6713 board and wanted to perform some real application (Signal to Noise). I use Simulink to programming DSP board but I don't know how can I run my program on DSP board. When i build my model in simulink gives me an error "RTDX target application does not match emulation protocol Loaded program was created with an rtdx library which does not match the target device"

How do I fix this error? Please help me! email me at caoh36(at)yahoo.com

  • 0
    TI__Guru**** 473241 points

    I have seen this error when I am trying to load an RTDX program that was built specifically for one target on another target. Please make sure that the application was built for a C6713 HW target.

  • 0 in reply to Ki
    TI__Expert 8055 points

    There is probably a setting in Simulink that you can change that will allow this to work.  For example, in DSP/Bios, there is a Simulation mode for RTDX and a JTAG mode for RTDX.  In order to use on a  real board, the application needs to be built for JTAG RTDX.

     

    Regards,
    Dan