TM4C123GH6PM: Uniflash v4 CLI programming error

Edward Chang

Part Number: TM4C123GH6PM
Other Parts Discussed in Thread: EK-TM4C123GXL, UNIFLASH

Hi,

I am trying to program TM4C123GH6PM using EK-TM4C123GXL board. I have followed the instruction to install all the drivers but it shows this error message.

Edward

over 9 years ago

0 Amit Ashara over 9 years ago

TI__Guru**** 244440 points

Moving it to the CCS Forum.

0 desouza over 9 years ago in reply to Amit Ashara

TI__Guru**** 171399 points

Edward,

I am not very familiar with the CLI interface of Uniflash v4 but, as a general statement, when you are writing .bin files to the device you forcefully need to pass an address to it (not "undefined"). The reason is that, differently than .out, .hex, etc., .bin files do not carry any code placement information.

Can you retry the command but passing a meaningful address to the last parameter?

Hope this helps,
Rafael

Code Composer Studio™︎

Code Composer Studio forum

TM4C123GH6PM: Uniflash v4 CLI programming error