CCS/AWR1443: How to add device support (for emulation) after CCS is already installed?

_Lina

Part Number: AWR1443

Tool/software: Code Composer Studio

Team,

Is there a way to add device support in CCS in regards to emulation packages post-CCS installation? I'm specifically looking to add AWRxx device support.

Best,

over 9 years ago

0 Ki over 9 years ago

TI__Guru**** 486661 points

Hi Lina,
Simply rerun the installer executable again and choose your existing CCS installation directory as the location. The installer will detect and existing installation and allow you to make changes (add any additional components you didn't initially install).

Thanks
ki

0 _Lina over 9 years ago

TI__Expert 3305 points

Just figured it out through other channels.

This can be done via the following:
1. Open CCS -> Help -> Install New Software
2. In "Work With:" -> All Available Sites
3. Navigate through list. For AWR devices, it was under "mmWave Radar Device support"

0 _Lina over 9 years ago in reply to Ki

TI__Expert 3305 points

Hi Ki,

Thanks for the quick response and alternative method!

Code Composer Studio™︎

Code Composer Studio forum

CCS/AWR1443: How to add device support (for emulation) after CCS is already installed?