• State Resolved
  • Locked Locked
  • Replies 4 replies
  • Subscribers 53 subscribers
  • Views 665 views
  • Users 0 members are here
Support feedback
Options
Options
Related

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

CCS: PinMux cloud tool ... can I import from Windows Pin Mux Utility 2.5.2.0 ?

Mark Jackson99390
Intellectual 285 points
Other Parts Discussed in Thread: AM3352

Tool/software: Code Composer Studio

I have an old design I did under Windows using the Pin Mux Utility v2.5.2.0.

These were saved as ".dat" files, but the new cloud tool uses a ".pinmux" file.

Is there any way import my old file into the new tool ?

Or am I forced to start from scratch ?

  • 0
    TI__Guru**** 162305 points
    Mark,

    Can you zip up the .dat file and attach? Also which device is this for? I am guessing based on the version that it was a Sitara (AM) device. Part of the challenge is that the underlying device data changed a while back so it is hard to map one to the other. If you can send the file we can take a look at see if there is something simple we can change to enable the file to be imported into the newer tool. If not, unfortunately you may need to start over in the new tool. The older tool is available for download if you want to stick with it as well.

    Regards,
    John
  • 0 in reply to JohnS
    Intellectual 285 points

    PinMuxDesignState_AM335x_Nano_v3.zip

    It's for an AM3352 ... zip file attached.

    It's not a huge issue to have to re-enter everything.  I was just checking before I go down that route.

    But if you *can* help me out, I'd be most grateful.

  • 0 in reply to Mark Jackson99390
    TI__Guru**** 162305 points
    Mark,

    Well the news isn't good. The data is just too old. I was thinking this was from our previous generation of the tool and maybe we could figure out some way to adjust it to the current one. However it is actually from the generation before that. So unfortunately it means you will have to re-enter the data to use the new tool.

    Regards,
    John
  • 0 in reply to JohnS
    Intellectual 285 points
    Ah well, I guess it was worth a try.

    Thanks for trying anyway :)